The heat pump is always counted among useful home appliances and it is responsible for maintaining a good ambience. It is often recommended to hire professionals for the job, but that’s not quite right.
Because if you are just replacing an older device, then you are probably aware of a few facts about the heat pump and can deal with the installation yourself.
However, if you don’t have any prior experience, then it is better you leave it to professionals because there can be more than one variable that you might find difficult to handle. You can use the following simple tips to install new heat pump in Rockville MD.
Study the user manual thoroughly
When you just buy a brand new heat pump make sure it has the user manual inside the box along with the warranty card. Usually, the warranty card is handed over to you by the seller with a stamp and validity.
So, if you are planning to install the device yourself it is important to update your knowledge with the facts about the appliance, and to do that there’s nothing better than the user manual.
The manufacturer knows its product better than anyone, and that’s why they give you precise tips for installation and heat pump repair in Rockville through the user manual. That’s why make sure you read it well before starting with the installation.
Analyze the new system and compare it with ducts
This point concerns both the new users and the old users both. In fact, you have to work on this point before you even buy the new heat pump. It is necessary to understand whether the new system you are buying is compatible with the old duct setting.
Also, if you are buying it the first time you’d need to take a look at your duct system to see whether it is good enough to work with the newly bought heat pump. For the new users, it is recommended to work with professionals to analyze the requirements of the new unit. If there’s something that needs to be changed the experts can do it easily.
Disconnect the old heat pump
The process kicks off with disconnecting the older unit and to do that you need to disconnect the breaker system and start from the indoor unit. Starting from the indoor unit makes the whole process easy. Because the old housing is much easier to disconnect from the supply and return vents.
It is important that you pay attention to while working around the coolant lines because they can be reused. Once you are done with the indoor unit, now it is time to remove the outdoor unit as well. It is relatively easy to remove because you just have to cut the pressure and suction lines and disconnect the power.
Connect the new outdoor and indoor unit
There’s a series of processes to install the new unit. Just move the new unit in the installation place and lay the new pan for the installation. It is not necessary that the new device will use the same coolant model as you had previously. If it needs to be replaced, then it is time to flush the coolant lines.
The old coolant isn’t useless, but it can be used with some other unit that requires a similar model to work. After that connect the thermostat wiring and connect the power as well. Finally, you’d need to install a filter dryer and braze the high-pressure line and the suction lines. Now you are all set to install the indoor unit. Just take the necessary measurement and do a custom installation.
Hire a professional to install
Installing a heat pump isn’t a simple task and you can lose track of stuff quite easily if you are not a professional. If you are stuck at some point, then it is better you contact a reliable installation company right away. The experts are quite fast at installation and they’d finish the job before you even know it.
The biggest advantage of working with professionals is that they are experienced and carry out a safe installation without damaging any of your things. It is true that hiring a professional might cost you, but the cost isn’t that high and you get a value-for-money service.
Heat pump repair Rockville MD can become a nightmare if you have little or no knowledge of the system. That’s why you should make your decision carefully about DIY or hiring a professional. Once the unit is installed, don’t just relax because it should be tested before giving a green signal. It is appropriate to move out the user manual and follow the guidelines precisely. If you hire a professional, then let him do it, otherwise, if you want to check it yourself, then it is better you consult the user manual.